+1 831 204 7780 | CONTACT US


You have no items in your shopping cart.

Product was successfully added to your shopping cart.

Acro Naze 32 (Rev6)

Quick Overview

DISCONTINUED, please see any modern F3 flight controller that we have available.

The World Famous Acro Naze 32.

Revision: 6B
Colors vary with each batch: Black / White / Pink / Orange / Green / Blue / Purple

* This board comes with the pin headers un-soldered, if you require them to be soldered for you, please read below.

Availability: Out of stock



Designed for use with small indoor or small to mid-sized outdoor multirotor crafts, or as a standalone camera stabilizer. The Naze32 flight controller is extremely simple to setup, with configuration based on the familiar “MultiWii” software. The Acro version is the same as the full Naze32 board except the full version comes with the MS5611 barometer and a magnetometer. 


  • STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
  • Invensense MPU6500 MEMS accelerometer + gyro
  • BMP280 Barometer
  • Battery voltage monitoring
  • Built-in FrSky telemetry converter
  • SBUS Inverter
  • 16mbit flash
  • Onboard USB for setup and configuration
  • Extra bright LEDs
  • Sonar pads w/resistors added for direct connection to 5V sonar
  • Fully compatible with OSDoge

Modern GUI for all operating systems, Baseflight Configurator (Chrome App)


  • Revision: 6
  • Height: 36mm
  • Width: 36mm
  • Weight: 6 grams (no headers, 8 grams with)
  • Sensors: MPU6050, BMP280

What you get

  • 1 x Acro Naze 32
  • 1 x 3x6 90 degree pin header
  • 1 x 1x2 straight pin header
  • 1 x 2x5 90 degree & straight pin headers
  • 1 x 1x10 90 degree & straight pin headers

Additional Notes

The user manual can be found here.

* The flight controller board comes with the needed pinheaders, but requires soldering. If you would like us to solder it for you, please add our Soldering Service product to your shopping cart on checkout.


Additional Information

Manufacturer Abusemark
Firmware Baseflight

Also Purchased